HP MSR Router Series User Manual

103
Configuring an HDLC link bundle interface
Configuration restrictions and guidelines
When you configure an HDLC link bundle interface, follow these restrictions and guidelines:
• The minimum number of Selected interfaces required cannot be greater than the maximum number
of Selected interfaces allowed in the HDLC link bundle.
• To guarantee correct traffic transmission, HP recommends that you configure each of the following
parameters the same at both ends of an HDLC link bundle:
{ Minimum number of Selected interfaces required for bringing up the HDLC link bundle.
{ Maximum number of Selected interfaces allowed in the HDLC link bundle.
{ Minimum bandwidth required for bringing up the HDLC link bundle.
• After the HDLC link bundle configuration is complete, the state of each member interface is
determined again if you modify any of the following parameters:
{ Minimum number of Selected interfaces required for bringing up the HDLC link bundle.
{ Maximum number of Selected interfaces allowed in the HDLC link bundle.
{ Minimum bandwidth required for bringing up the HDLC link bundle.
• HP recommends that you set the same load balancing mode at both ends of an HDLC link bundle.
Configuration procedure
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an HDLC link bundle
interface and enter its view.
interface hdlc-bundle bundle-id
By default, no HDLC link bundle
interface exists.
3. Set the load balancing mode.
bundle load-balance { per-flow |
per-packet }
By default, per-packet load
balancing applies.
4. (Optional.) Specify a primary
traffic processing card for the
HDLC link bundle interface.
(Distributed devices in
standalone mode.)
service slot slot-number
By default, no primary traffic
processing card for the HDLC link
bundle interface is specified.
5. (Optional.) Specify a primary
traffic processing device for
the HDLC link bundle
interface. (Centralized
devices in IRF mode.)
service slot slot-number
By default, no primary traffic
processing device for the HDLC link
bundle interface is specified.
6. (Optional.) Specify a primary
traffic processing card for the
HDLC link bundle interface.
(Distributed devices in IRF
mode.)
service chassis chassis-number slot
slot-number
By default, no primary traffic
processing card for the HDLC link
bundle interface is specified.

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English