HP MSR Router Series User Manual

10
To set the keepalive retry limit, use the timer-hold retry command.
On a slow link, increase the keepalive interval to prevent false shutdown of the interface. This situation
might occur when keepalives are delayed because a large packet is being transmitted on the link.
To disable sending of keepalives, set the keepalive interval to 0.
To configure the polling feature:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Set the keepalive interval.
timer-hold seconds The default setting is 10 seconds.
4. Set the keepalive retry limit.
timer-hold retry retry The default setting is 5.
Configuring PPP negotiation
PPP negotiation includes the following parameters:
• Negotiation timeout time
• IP address negotiation
• IP segment match
• DNS server IP address negotiation
• ACCM negotiation
• ACFC negotiation
• PFC negotiation
Configuring the PPP negotiation timeout time
The device starts the PPP negotiation timeout timer after sending a packet. If no response is received
before the timer expires, the device sends the packet again.
To configure the PPP negotiation timeout time:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the negotiation
timeout time.
ppp timer negotiate seconds The default setting is 3 seconds.
Configuring IP address negotiation
To configure the device as the client:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English