HP MSR Router Series

46
• As shown in Figure 11, a PPPoE session is established between each host (PPPoE client) and the
carrier router (PPPoE server). The service provider assigns an account to each host for billing and
control. The host must be installed with PPPoE client software.
Figure 11 Network structure 2
Command and hardware compatibility
Commands and descriptions for centralized devices apply to the following routers:
• MSR1002-4/1003-8S.
• MSR2003.
• MSR2004-24/2004-48.
• MSR3012/3024/3044/3064.
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
Configuring the PPPoE server
Configuring a PPPoE session
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VT interface and
enter VT interface view.
interface virtual-template number N/A
3. Set PPP parameters.
See "Configuring PPP
."
If authentication is needed, use
the PPPoE server as the
authenticator.
4. Enable MRU detection.
ppp lcp echo mru verify [ minimum
value ]
By default, MRU detection is
disabled.
5. Return to system view.
quit N/A
Internet
PPPoE Server
Host A
Host B
Router
PPPoE Client
PPPoE Client