HP MSR Router Series

23
Ste
p
Command Remarks
3. Set the binding mode.
ppp mp binding-mode
{ authentication | both | descriptor }
By default, both the username
and the descriptor are used for
MP binding.
4. (Optional.) Set the maximum
number of links in an MP
bundle.
ppp mp max-bind max-bind-num The default setting is 16.
5. (Optional.) Set the minimum
number of links in an MP
bundle.
ppp mp min-bind min-bind-num
The default setting is 0, which
means MP dialup depends on
traffic detection.
This command is available only in
dialer interface view.
The minimum number cannot be
greater than the maximum
number set with the ppp mp
max-bind command.
6. Set the minimum size of MP
fragments.
ppp mp min-fragment size The default setting is 128 bytes.
7. Configure the MP sort buffer
size factor.
ppp mp sort-buffer-size size The default setting is 1.
8. (Optional.) Configure the
timer for MP to wait for the
expected fragment.
ppp mp timer lost-fragment seconds
By default, the timer is 30
seconds.
9. (Optional.) Disable MP
fragmentation.
ppp mp fragment disable
By default, MP fragmentation is
enabled.
When this command is
configured on an interface, the
ppp mp lfi enable and ppp mp
min-fragment commands do not
take effect on the interface.
Configuring MP through an MP-group interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an MP-group interface
and enter its view.
interface mp-group mp-number
If the MP-group interface already
exists, you enter its view directly.
3. (Optional.) Set the maximum
number of links in an MP
bundle.
ppp mp max-bind max-bind-num
The default setting is 16.
For this command to take effect on
an MP bundle, you must re-enable
all the physical interfaces in the MP
bundle by executing the shutdown
command and then the undo
shutdown command.
4. Set the minimum MP packet
size for fragmentation.
ppp mp min-fragment size The default setting is 128 bytes.
5. Configure the MP sort buffer
size factor.
ppp mp sort-buffer-size size The default setting is 1.