HP MSR Router Series User Manual

51
• Creating or removing a VA pool takes time. During the process of creating or removing a VA pool,
users can go online or offline, but the VA pool does not take effect.
• The system might create a VA pool that contains VA interfaces less than the specified number
because of insufficient resources. In this case, you can use the display pppoe-server va-pool
command to view the number of available VA interfaces and current state of the VA pool.
• Deleting a VA pool does not log off the users who are using VA interfaces in the VA pool.
To configure a VA pool:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VA pool (centralized
devices in standalone mode).
pppoe-server virtual-template
template-number va-pool va-volume
By default, no VA pool exists.
3. Create a VA pool (distributed
devices in standalone
mode/centralized devices in
IRF mode).
pppoe-server virtual-template
template-number [ slot slot-number ]
va-pool va-volume
By default, no VA pool exists.
4. Create a VA pool (distributed
devices in IRF mode).
pppoe-server virtual-template
template-number [ chassis
chassis-number slot slot-number ]
va-pool va-volume
By default, no VA pool exists.
Clearing PPPoE sessions
To clear PPPoE sessions on the PPPoE server:
Ste
p
Command Remarks
1. Enter user view.
user-view N/A
2. Clear PPPoE sessions.
reset pppoe-server { all | interface
interface-type interface-number |
virtual-template number }
N/A
Configuring a PPPoE client
PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.
A PPPoE session can operate in one of the following modes:
• Permanent mode—A PPPoE session is established immediately when the line is physically up. This
type of session remains until the physical link comes down or until the session is disconnected.
• On-demand mode—A PPPoE session is established when there is a demand for data transmission
instead of when the line is physically up. It is terminated when idled for a specific period of time.
• Diagnostic mode—A PPPoE session is established immediately after the device configurations finish.
The device automatically terminates the PPPoE session and then tries to re-establish a PPPoE session
at a pre-configured interval. By establishing and terminating PPPoE sessions periodically, you can
monitor the operating status of the PPPoE link.
The PPPoE session operating mode is determined by your configuration on the dialer interface:

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English