HP MSR Router Series User Manual

165
Specifying the primary and backup profiles
By default, profile 1 is used for 3G/4G modem dialup. The dialup fails if profile 1 does not exist.
You can also specify the primary and backup profiles for 3G/4G modem dialup. The primary profile
always has priority over the backup profile. For each dialup connection establishment, the 3G or 4G
modem uses the backup profile only when it has failed to dial up using the primary profile.
You must configure the same username and password for the primary and backup profiles.
To specify the primary and backup profiles:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cellular interface view.
controller cellular interface-number N/A
3. Specify the primary and
backup profiles
profile main main-profile-number
backup backup-profile-number
By default, profile 1 is used for 3G
or 4G modem dialup.
Configuring PIN verification
A UIM card is used in the CDMA network and a SIM card is used in other mobile networks. Each
SIM/UIM card has a Personal Identification Number (PIN). PIN verification prevents unauthorized
access to the SIM/UIM card.
To perform PIN verification, you need to save the PIN of the SIM/UIM card on the device by using the pin
verify command and enable PIN verification. The pin verify command can be executed before and after
you enable PIN verification. After the PIN is saved on the device, the PIN is used for verification
automatically when required.
When PIN verification is enabled, PIN verification is performed after you perform any of the following
tasks:
• Install a 3G/4G modem.
• Reboot the device where a USB 3G/4G modem is attached.
• Execute the modem reboot command to reboot a 3G/4G modem.
• Hot swap a USB 3G/4G modem.
• Cold boot the device where a SIC-3G/4G modem is installed.
If PIN verification fails after a maximum number of attempts, the SIM/UIM card is locked, and a PIN
Unlocking Key (PUK) is required to unlock the card. The maximum number of attempts depends on the
3G/4G modem model.
To configure PIN verification:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cellular interface view.
controller cellular interface-number
N/A

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English