HP MSR Router Series User Manual

22
Ste
p
Command Remarks
9. (Optional.) Specify a backup
traffic processing unit for the VA
interfaces of the VT interface.
• Distributed devices in standalone
mode/centralized devices in IRF
mode:
service standby slot slot-number
• Distributed devices in IRF mode:
service standby chassis
chassis-number slot slot-number
By default, no backup traffic
processing unit is specified.
10. (Optional.) Restore the default
settings for the VT interface.
default N/A
11. Return to system view.
quit N/A
12. Associate a physical interface
or a username with the VT
interface.
• (Method 1) Bind a physical
interface to the VT interface:
a. Enter interface view:
interface interface-type
interface-number
b. Bind the interface to the
specified VT interface, and
enable MP for the interface:
ppp mp virtual-template
number
c. (Optional.) Configure PPP
authentication (see
"Configuring PPP
authentication.")
• (Method 2) Associate a username
to the VT interface:
d. Associate a VT interface to a
username:
ppp mp user username bind
virtual-template number
e. Enter interface view:
interface interface-type
interface-number
f. Enable MP for the interface:
ppp mp
g. Configure PPP authentication
(see "Configuring PPP
authentication.")
By default, a physical
interface is enabled with PPP
and not bound to any VT
interface.
PPP authentication does not
affect MP when Method 1 is
used.
By default, a VT interface is
not bound to any username.
13. Configure other MP parameters.
See "Configuring other optional
parameters."
N/A
Configuring other optional parameters
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MP VT interface or
dialer interface view.
interface { dialer | virtual-template }
number
For more information about
configuring MP parameters in
dialer interface view, see
"Configuring DDR."

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English