1-21
Introducing the Switch
Back of the Switch
Console Port
This port is used to connect a console to the switch by using the serial cable
supplied with the switch. This connection is described under “9. (Optional)
Connect a Console to the Switch” on page 21 in chapter 2, “Installing the
Switch.” The console can be a PC or workstation running a VT-100 terminal
emulator, or a VT-100 terminal. The console port is located on the front of the
3500-24, 3500-24-PoE, 3500yl-24G-PWR, 3500yl-24G-PoE+, 3500yl-48G-PoE+
and 6200yl-24G switches, and on the back of the 3500-48, 3500-48 and 3500yl-
48G-PWR switches.
Power Connector
The 3500, 3500yl and 6200yl switches do not have a power switch; they are
powered on when connected to an active AC power source. These switches
automatically adjust to any voltage between 100--240 volts and either 50 or 60
Hz. There are no voltage range settings required.
To Next Page
Loading...
