HP ProCurve 3500 - Page 42

2-6
Installing the Switch
Installation Procedures
Installing the Switch
Note The 3500, 3500yl and 6200yl switches do not have a power switch. They are
powered on when the power cord is connected to the switch and to a power
source. For safety, the power outlet should be located near the switch
installation.
The switch automatically adjusts to any voltage between 100-127 and 200-240
volts and either 50 or 60 Hz. No voltage range settings are required.
If your installation requires a different power cord than the one supplied with
the switch, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the switch.
2. Check the LEDs on the switch as described below.
Figure 2-2. Example of an HP ProCurve 24 port switch
Figure 2-3. Example of an HP ProCurve 48 port switch
Fault
Power
Locator
LED
Mode
Clear
Reset
PoE-Integrated 10/100/1000Base-T Ports (1 - 24T)  Ports are IEEE Auto MDI/MDI-X
Te st
Tm p
Status
PoE
Fan
Usr
FDx
Spd
PoE
Act
*
14 16
17
15
13
12
10864
2
11
97
5
3
1
18
Link
Mode
Link
Mode
Link
Mode
Link Mode
Console
Auxiliary Port
Status of the Back
Mdl
RPSEPS
ProCurve Switch
3500yl-24G
J8692A
Spd mode: off = 10 Mbps
flash = 1
00 Mbps
on = 1000 Mbps
*
PoE
Switch port LEDs
Power and
Fault LEDs
Test LED
Fault
Power
Locator
LED
Mode
Clear
Reset
PoE-Integrated 10/100/1000Base-T Ports (1 - 48T)  Ports are IEEE Auto MDI/MDI-X
Tes t
Tm
p
Status
PoE
Fan
*
Spd mode: off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
FDx
Spd
PoE
Act
*
12
10
864
2
119
7
5
3
1
Link
Mode
Link
Mode
Status of the Back
Mdl RP
SEPS
ProCurve Switch
3500yl-48G
J8692A
24
222018
16
14
232119171513
Link Mode
Link
Mode
3028
26
292725
Link Mode
Link
Mode
Usr
PoE
Switch port LEDs
Power and
Fault LEDs
Test LED