Network Controller
HP 361i Integrated Dual Port Gigabit Server Adapter
Expansion Slots #
Technology
Bus Width
Connector Width
*
Form Factor
Notes
1
PCIe 3.0
X16
x16
Half length, full
height or Full length,
full height
2
PCIe 3.0
X8
x8
Low Profile
Internal only
NOTE:
*Indicates the number of physical electrical lanes running to the connector.
NOTE:
In order to access expansion slot #2 (the low profile internal only slot), expansion slot #1 may only be
populated with a half length, full height form factor card. If full length card is installed on the slot #1, low profile
internal only slot will be inaccessible.
HP Server ROM
HP ROM (Read Only Memory) is now digitally signed using HP's Corporate Signing Service. This signature is
verified before the flash process starts, reducing accidental programming and preventing malicious efforts
to corrupt system ROM.
HP ROM provides for essential initialization and validation of hardware components before control is
passed to the customer-installed operating system. The ROM also provides the capability of booting from
various fixed media (HDD, CD-ROM) and removable media (USB), to continue operation to the operating
system.
HP ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log (IML) to
assist in diagnosis.
HP's ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Customer-specific BIOS configuration (using the HP ROM-Based Setup Utility (RBSU).
NOTE:
For further information, please refer to HP's RBSU (ROM based setup utility) user guide:
http://www.hp.com/support/rbsu
.
Storage Controller
One of the following
depending on Model
Entry Models
HP Dynamic Smart Array B120i controller
Base Models
HP Dynamic Smart Array B120i controller
Performance Models
HP Smart Array P420/1GB FBWC controller
NOTE:
Available upgrades: 512MB FBWC for B120i, 2GB FBWC for P420 Controller/ 1GB FBWC controller
NOTE:
HP Dynamic Smart Array B120i controller supports up to 3Gb/s speed in HP ProLiant DL160 Gen8.
HP Smart Array controller is required in PCIe slot to achieve 6Gb/s.
QuickSpecs
HP ProLiant DL160 Generation 8 (Gen8)
Standard Features
DA - 14282 Worldwide — Version 22 — December 13, 2013
Page 4
To Next Page
Loading...
