Removal and replacement procedures 23
8.
Remove the component from the server.
To replace the component, reverse the removal procedure.
PCI riser board assembly
CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all
AC power cords before removing or installing the PCI riser cage.
IMPORTANT: Be sure that all DIMM slot latches are closed to provide adequate clearance before
removing the PCI riser board assembly with a half-length expansion board.
1. Power down the server ("Powering down the server" on page 11).
2. Extend the server from the rack, if applicable ("Extending the server from the rack" on page 11).
3. Remove the access panel ("Removing the access panel" on page 13).
4. Remove the PCI riser board assembly:
a. Disconnect any internal or external cables connected to any existing expansion boards.
b. Loosen the four PCI riser board assembly thumbscrews.
To Next Page
Loading...
