EasyManua.ls Logo

HP ProLiant DL360 Generation 4p - Hot-Plug Power Supply Calculations; DDR2 SDRAM DIMM Specifications

HP ProLiant DL360 Generation 4p
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Specifications 56
Specification Value
Maximum wet bulb temperature 28°C (82.4°F)
Relative humidity
(noncondensing)**
Operating 10% to 90%
Non-operating 5% to 95%
* All temperature ratings shown are for sea level. An altitude derating of 1°C per 300 m (1.8°F per 1,000 ft) to
3048 m (10,000 ft) is applicable. No direct sunlight allowed.
** Storage maximum humidity of 95% is based on a maximum temperature of 45°C (113°F). Altitude maximum for
storage corresponds to a pressure minimum of 70 KPa.
Hot-plug power supply calculations
For hot-plug power supply specifications and calculators to determine electrical and heat loading for the
server, refer to the HP Enterprise Configurator website (http://h30099.www3.hp.com/configurator/
).
DDR2 SDRAM DIMM specifications
NOTE: Use only 256-MB, 512-MB, 1-GB, or 2-GB; 72-bit wide; 2.5-V; PC2-3200 Registered ECC DDR2
SDRAM. Use HP DDR2 SDRAM only.
Item Description
Size 256 MB, 512 MB, 1 GB, 2 GB
Width 72 bits
Upgrade requirement
Any combination of like-paired DDR2 SDRAM DIMMs that
provide a minimum of 512 MB
1.44-MB diskette drive specifications
Specification Value
Dimensions
Height 12.7 mm (0.5 in)
Width 96 mm (3.8 in)
Depth 130 mm (5.1 in)
LEDs (front panel) Green = On
Read/write capacity per
diskette
High density 1.44 MB
Low density 720 KB
Drives supported 1
Drive height One-third height
Drive rotation 300 rpm
Transfer rate
High 500 Kb/s

Related product manuals