Removal and replacement procedures 31
To replace the component, reverse the removal procedure.
Multibay device ejector
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 26, "Remove
the server from the rack" on page 27).
3. Remove any device in the multibay ("Multibay blank or device" on page 30).
4. Remove all hard drives ("Hot-plug SAS or SATA hard drives" on page 28) and hard drive blanks (on
page 27).
5. Remove the front bezel ("Front bezel" on page 29).
6. Remove the two T-10 Torx screws that secure the multibay device ejector to the server chassis.
7. Press the tab on the side of the multibay device ejector to release it from the chassis.
To Next Page
Loading...
