HP ProLiant DL360 Generation 5 - Page 43

Removal and replacement procedures 43
13.
Remove the backplane.
To replace the component, reverse the removal procedure.
Systems Insight Display
The Systems Insight Display is an assembly that includes the front panel LEDs, Power On/Standby button,
and a cable.
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 26, "Remove
the server from the rack" on page 27).
3. Remove the access panel ("Access panel" on page 27).
4. Remove all hard drives ("Hot-plug SAS or SATA hard drives" on page 28) and hard drive blanks (on
page 27).
5. Remove the front bezel ("Front bezel" on page 29).
6. Remove the processor air baffle ("Processor air baffle" on page 36).
7. Remove fan module 3 ("Fan modules" on page 37).
8. Remove any device in the multibay ("Multibay blank or device" on page 30).
9. Remove the multibay backplane ("Multibay backplane assembly" on page 38).
10. Disconnect the Systems Insight Display cable.