HP ProLiant DL360 Generation 5 - Page 44

Removal and replacement procedures 44
11.
Remove the T-15 Torx screw that secures the Systems Insight Display.
12. Remove the Systems Insight Display.
To replace the component, reverse the removal procedure.
Integrated HP Smart Array E200i Controller or HP
Smart Array P400i Controller
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 26, "Remove
the server from the rack" on page 27).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the power supply air baffle ("Power supply air baffle" on page 36).