Removal and replacement procedures 45
5.
Disconnect all cables from the integrated array controller.
6. Disconnect the backplane power cable from the system board.
7. Turn the quarter-turn fasteners counter-clockwise.
8. Remove the integrated array controller.
To replace the component, reverse the removal procedure.
HP Smart Array E200i Controller memory module
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 26, "Remove
the server from the rack" on page 27).
3. Remove the access panel ("Access panel" on page 27).
To Next Page
Loading...
