HP ProLiant DL360 Generation 5 - Page 46

Removal and replacement procedures 46
4.
Remove the power supply air baffle ("Power supply air baffle" on page 36).
5. Remove the existing memory module.
To replace the component, reverse the removal procedure.
HP Smart Array P400i Controller memory module
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 26, "Remove
the server from the rack" on page 27).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the power supply air baffle ("Power supply air baffle" on page 36).
5. Remove the existing memory module.