HP ProLiant DL380 Generation 5

Removal and replacement procedures 44
8.
Remove the processor fan bracket plate.
To replace the component, reverse the removal procedure.
Media drive ejector assembly
To remove the component:
1. Power down the server (on page 30).
2. Extend or remove the server from the rack ("Remove the server from the rack" on page 31).
3. Remove the access panel ("Access panel" on page 32).
4. Remove the media drive ("Media drive or blank" on page 37).
5. Remove the processor fan bracket ("Processor fan bracket" on page 39).
6. Remove the fan board ("Fan board" on page 42).
7. Remove the processor fan bracket plate ("Processor fan bracket plate" on page 43).