Removal and replacement procedures 29
o
Extend the server from the rack (on page 27).
2. Open the locking latch, slide the access panel to the rear of the chassis, and remove the access
panel.
If the locking latch is locked, use a T-15 Torx screwdriver to unlock the latch.
Remove the processor memory drawer
1. Power down the server (on page 26).
2. Release the latches on the release lever.
3. Lower the handle, and then extend the processor memory drawer from the server until the release
latches catch.
WARNING: The processor memory drawer weighs more than 11.3 kg (25.0 lb). Use extra
caution when removing and replacing the processor memory drawer.
To Next Page
Loading...
