HP ProLiant DL585 G7 - Installing hardware options; Installing the server into the rack; Powering up and configuring the server

Removal and replacement procedures 33
I/O enabler board
1. Power down the server (on page 26).
2. Remove the processor memory drawer (on page 29).
3. Remove the processor memory drawer cover.
4. Remove the tray containing the I/O enabler board ("Remove the tray" on page 30).
To replace the component, reverse the removal procedure.
CAUTION: When installing the tray with the secondary processor memory board, be sure that
all DIMM latches on the primary processor memory board are in the fully-locked position.
Failure to do so results in damage to the primary processor memory board.
Secondary processor memory board
1. Power down the server (on page 26).
2. Remove the processor memory drawer (on page 29).
3. Remove the processor memory drawer cover.
4. Remove the tray containing the secondary processor memory board ("Remove the tray" on page
30).
To replace the component, reverse the removal procedure.