Removal and replacement procedures 35
To replace the component:
1. Clean the old thermal grease from the top of the processor with the alcohol swab. Allow the alcohol
to evaporate before continuing.
2. Remove the heatsink protective cover.
3. Install the heatsink.
CAUTION: When installing the tray with the secondary processor memory board, be sure that
all DIMM latches on the primary processor memory board are in the fully-locked position.
Failure to do so results in damage to the primary processor memory board.
4. Install the tray.
5. Install the processor memory drawer cover.
6. Install the processor memory drawer.
7. Power up the server.
To Next Page
Loading...
