To Next Page

To Previous Page

Removal and Replacement Procedures

Figure 2-15: Removing the IDE CD-ROM drive

5. Place the old CD-ROM on a static-dissipating work surface or inside an anti-static bag.

6. Remove the new CD-ROM from its protective packaging.

7. Check that the IDE jumper on the rear section of the CD-ROM drive is set to

Cable-Select mode.

8. Install the new CD-ROM drive:

a. Guide the new CD-ROM drive into the CD-ROM bay, with the cable connectors

facing the rear of the chassis, then push the drive all the way into the chassis until the

mounting holes are aligned.

b. Press the drive-retaining lever downward.

c. Move the lever into its retaining hook to secure the new drive in place.

d. Connect the IDE power and data cables to their connectors on the rear of the drive.

HP ProLiant ML110 Generation 2 Server Maintenance and Service Guide 2-15

Other manuals for HP ProLiant ML110 - G2 Server

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant ML110 - G2 Server and is the answer not in the manual?

General

Server Type	Tower
Chipset	Intel E7210
Memory Type	DDR SDRAM
Maximum Memory	4 GB
Optical Drive	Optional
Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Pentium 4
Storage Controller	Integrated SATA
Drive Bays	2 x 3.5" internal
Network Controller	Integrated Broadcom Gigabit Ethernet
Power Supply	300W
Operating System Support	Microsoft Windows Server 2003, Red Hat Linux