HP ProLiant ML115 G5 - Page 25

Interface SATA
Access Times (typical) Random <100 ms
Full-Stroke <150 ms
Data Transfer Rate Sustained 3000 to 7200 KB/s (20X to 48X)
Burst 150 KBps to 7,200 KBps
Bus Rate 1.5Gbps
Cache Buffer 128 KB
Start-up Time (typical) < 7 seconds
Stop Time < 4 seconds
Laser Parameters Type Semiconductor Laser GaA1As
Wave Length 780 ± 25 nm
Operating Conditions Temperature 41° to 122° F (5° to 50° C)
Humidity 10% to 90%
Dimensions (HxWxD, maximum) 1.63 x 5.75 x 7.87 in (41.3 x 146 x 195 mm)
Weight 2.64 lb (1.2 kg)
4 port Embedded SATA
controller
SATA Protocol SATA 2, 3Gb/s
SATA Ports 4 internal
Port transfer rate 1.5 Gb/s total
Maximum Capacity up to 3.0TB (4 x 750GB non-hot plug SATA HDD)
RAID Levels Supported RAID 1+0 (Striping & Mirroring)
RAID 1 (Mirroring)
RAID 0 (Striping)
RAID 5 (Striping with parity)
Logical RAID Volumes
Supported
NOTE: On SATA models with embedded RAID, setup instructions are
located in User Guide, CTO RAID is set-up is not available. HP ProLiant
100 Series Server User Guide:
http://h20000.www2.hp.com/bc/docs/support/
SupportManual/c00260539/c00260539.pdf
Embedded NC105i PCIe
Gigabit Server Adapter
Network Interface 10Base-T/100Base-TX/1000Base-TX
Compatibility IEEE 802.3 10Base-T
IEEE 802.3ab 1000Base-T
IEEE 802.3u 100Base-TX
Data Transfer Method Single lane (x1), 100MHz PCI Express Reference Clock
Network Transfer Rate 10Base-T (Half-Duplex) 10 Mb/s
10Base-T (Full-Duplex) 20 Mb/s
100Base-TX (Half-
Duplex)
100 Mb/s
100Base-TX (Full-
Duplex)
200 Mb/s
1000Base-TX (Half and
Full-Duplex)
2000Mb/s
Connector RJ-45 connector
Cable Support 10Base-T Categories 3, 4 or 5 UTP; up to 328 ft (100 m)
10/100/1000Base-TX Category 5 UTP; up to 328 ft (100 m)
QuickSpecs
HP ProLiant ML115 Generation 5
Technical Specifications
DA - 13013 Worldwide QuickSpecs — Version 10 — 12.15.2008 Page 25