Removal and replacement procedures 33
To replace the component, reverse the removal procedure.
CD-ROM/DVD-ROM drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 25).
2. Remove the server from the rack, if necessary ("Remove the server from the rack" on page 25).
3. Remove the bezel ("Unlock the tower bezel" on page 26).
4. Remove the access panel ("Access panel" on page 26).
5. Disconnect the power and data cables.
6. Remove the CD-ROM or DVD-ROM drive.
To replace the component, reverse the removal procedure.
Hot-plug power supply
CAUTION: Leave all failed power supplies installed until ready to replace with a working power supply.
1. Disconnect the power cord of the failed power supply from the AC power source.
2. Disconnect the power cord from the failed power supply.
To Next Page
Loading...
