Hardware options installation 26
The following table lists some, but not all, possible configurations. For best performance, HP recommends
dual-channel interleaved mode configurations.
Slot 1A Slot 2B Slot 3A Slot 4B Total memory Mode
512 MB — — — 512 MB Single-channel
512 MB — 512 MB — 1 GB Dual-channel interleaved
1 GB — — — 1 GB Single-channel
1 GB — 1 GB — 2 GB Dual-channel interleaved
2 GB — — — 2 GB Single-channel
2 GB — 2 GB — 4 GB Dual-channel interleaved
2 GB 2 GB 2 GB — 6 GB Dual-channel asymmetric
2 GB 2 GB 2 GB 2 GB 8 GB Dual-channel interleaved
Installing DIMMs
1. Power down the server (on page 16).
2. Remove the access panel (on page 17).
3. Open the DIMM slot latches.
4. Install the DIMM.
5. Install the access panel (on page 17).
6. Power up the server (on page 16).
Hard drives
The server supports the hot-plug SAS and SATA hard drives.
Optional non-hot-plug SATA or SAS hard drives may be supported in select configurations ("SAS
controller" on page 28).
NOTE: The SATA RAID feature supports up to two RAID volumes with up to four hard drives per
RAID volume.
To Next Page
Loading...
