To Next PageTo Next Page
Need help?Do you have a question about the HP ProLiant ML310e and is the answer not in the manual?
General| Bus type | DMI |
|---|---|
| Stepping | C0 |
| FSB Parity | No |
| Scalability | 1S |
| Processor cache | 8 MB |
| Processor cores | 4 |
| Processor model | E3-1220V3 |
| System bus rate | 5 GT/s |
| Processor series | Intel Xeon E3-1200 v3 |
| Processor socket | LGA 1150 (Socket H3) |
| Processor codename | Haswell |
| Motherboard chipset | Intel® C222 |
| Processor frequency | 3.1 GHz |
| Processor cache type | Smart Cache |
| Processor lithography | 22 nm |
| Processor manufacturer | Intel |
| Processor package size | 37.5 x 37.5 mm |
| Processor front side bus | - MHz |
| Processor boost frequency | 3.5 GHz |
| Processor operating modes | 64-bit |
| ECC supported by processor | Yes |
| PCI Express configurations | 1x8, 1x16, 2x4, 2x8 |
| Supported instruction sets | AVX 2.0, SSE4.1, SSE4.2 |
| Thermal Design Power (TDP) | 80 W |
| Number of processors installed | 1 |
| Thermal solution specification | PCG 2013D |
| Maximum number of PCI Express lanes | 16 |
| Memory types supported by processor | DDR3-SDRAM |
| Memory channels supported by processor | Dual |
| Memory clock speeds supported by processor | 1333, 1600 MHz |
| Memory bandwidth supported by processor (max) | 25.6 GB/s |
| Maximum internal memory supported by processor | 32 GB |
| HDD size | 3.5 \ |
| HDD speed | 7200 RPM |
| RAID levels | 0, 1, 10 |
| HDD interface | Serial ATA III |
| Optical drive type | DVD-RW |
| Total storage capacity | 1000 GB |
| Maximum storage capacity | 16 TB |
| Supported storage drive interfaces | SAS, Serial ATA |
| Internal memory | 4 GB |
| Memory clock speed | 1333 MHz |
| Memory layout (slots x size) | 1 x 4 GB |
| Maximum graphics card memory | 16 MB |
| On-board graphics card model | Not available |
| Graphics card | G200 |
| Graphics card family | Matrox |
| Intel® Virtualization Technology (Intel® VT) | VT-d, VT-x |
| Cabling technology | 10/100/1000Base-T(X) |
| Ethernet interface type | Gigabit Ethernet |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity | 2 |
| PCI Express slots version | 3.0 |
| Operating system installed | - |
| Compatible operating systems | Windows Server\\r Ubuntu\\r Red Hat Enterprise Linux\\r SUSE Linux Enterprise Server\\r VMware |
| Noise level | 26 dB |
| Chassis type | Tower (4U) |
| Power supply | 350 W |
| Power supply input frequency | 47/63 Hz |
| Certification | FCC; CISPR 22; EN55022; EN55024; FCC CFR 47; ICES-003; CNS13438; GB9254; K22; K24; EN 61000-3-2; EN 61000-3-3; EN 60950-1; IEC 60950-1 |
| Processor ARK ID | 75052 |
| Intel Identity Protection Technology version | 1.00 |
Weight and Dimensions| Depth | 475.2 mm |
|---|---|
| Width | 175 mm |
| Height | 368.2 mm |
| Weight | 18960 g |
Identifies physical components on the server's front panel.
Details the status and function of front panel LEDs and buttons.
Identifies physical components on the server's rear panel.
Explains the status and function of rear panel LEDs and buttons.
Locates and describes components on the server's system board.
Step-by-step guide to powering on the server.
Procedures for safely shutting down the server.
Steps to remove the server's side access panel.
Steps to reattach the server's side access panel.
Specifies clearance needed for proper server ventilation.
Details acceptable operating temperature ranges for the server.
Outlines electrical regulations and power needs for installation.
Specifies safety grounding procedures for server installation.
Lists critical safety warnings and precautions for server handling.
Provides safety warnings related to rack installation and stability.
General guidance on installing server hardware options.
Instructions for mounting the server in a rack.
Procedures for installing the server's operating system.
Steps for initial server power-on and boot configuration.
Overview of supported drive types and configurations.
General rules for installing server hard drives.
Step-by-step guide to installing non-hot-plug drives.
Step-by-step guide to installing hot-plug drives.
Installation guide for a specific LFF drive backplane.
Step-by-step process for installing a storage controller.
Step-by-step guide to installing a DIMM.
Information on installing and enabling the TPM.
Procedure to install the TPM board.
Steps to enable the TPM functionality.
Details on the Integrated Lights-Out management subsystem.
Guide to the server's embedded OS deployment tool.
Utility for system diagnostics and troubleshooting.
Comprehensive firmware and software update package.
Tool for deploying firmware and software updates.
Utility for configuring server BIOS settings.
Instructions on how to navigate and use RBSU.
Utility for managing RAID arrays.
Importance of updating server software and firmware.
Lists guides and resources for resolving server issues.
Precautions to avoid damaging components with static electricity.
Methods for proper grounding to prevent ESD.
Details specifications for the server's power supplies.
