Hardware options installation 44
7.
Install the optical drive into the media drive bay.
8. Connect the drive cables:
a. Connect the power cable to the drive.
b. Connect one end of the SATA cable to the drive and the other end to the system board.
For cable routing information, see "Media drive cabling (on page 64)."
9. Install the access panel (on page 21).
10. Install the tower bezel (on page 19).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (on page 18).
Memory options
To Next Page
Loading...
