HP ProLiant ML310 - Page 28

Hardware options installation 28
4.
Install the hard drive.
5. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations.
6. Install the bezel ("Unlock the tower bezel" on page 17).
7. Resume normal server operations.
SAS controller
1. Power down the server (on page 16).
2. Remove the bezel ("Unlock the tower bezel" on page 17).
3. Remove the access panel (on page 17).
4. Remove the expansion slot cover ("Removing the expansion slot cover" on page 34).
5. Install the SAS controller, and press down firmly to seat the board in the connector.
6. Disconnect the SAS cable from the system board and connect it to the SAS controller ("SAS cabling"
on page 37).