172 Reference and Troubleshooting Guide
Cache Has Been Disabled Because ADG Enabler Dongle is Broken or Missing......................180
Cache Has Been Disabled; Likely Caused By a Loose Pin on One of the RAM Chips.............180
Configuration Signature is Zero .................................................................................................180
Configuration Signature Mismatch ............................................................................................180
Controller Communication Failure Occurred.............................................................................181
Controller Detected. NVRAM Configuration not Present..........................................................181
Controller Firmware Needs Upgrading ......................................................................................181
Controller is Located in Special "Video" Slot............................................................................181
Controller Is Not Configured......................................................................................................182
Controller Reported POST Error. Error Code: X .......................................................................182
Controller Restarted with a Signature of Zero............................................................................182
Disable Command Issued ...........................................................................................................182
Drive (Bay) X Firmware Needs Upgrading................................................................................183
Drive (Bay) X has Insufficient Capacity for its Configuration ..................................................183
Drive (Bay) X has Invalid M&P Stamp .....................................................................................183
Drive (Bay) X Has Loose Cable.................................................................................................183
Drive (Bay) X is a Replacement Drive.......................................................................................184
Drive (Bay) X is a Replacement Drive Marked OK...................................................................184
Drive (Bay) X is Failed ..............................................................................................................184
Drive (Bay) X is Undergoing Drive Recovery...........................................................................184
Drive (Bay) X Needs Replacing.................................................................................................184
Drive (Bay) X Upload Code Not Readable ................................................................................185
Drive (Bay) X Was Inadvertently Replaced...............................................................................185
Drive Monitoring Features Are Unobtainable............................................................................185
Drive Monitoring is NOT Enabled for SCSI Port X Drive ID Y ...............................................185
Drive Time-Out Occurred on Physical Drive Bay X..................................................................186
Drive X Indicates Position Y......................................................................................................186
Duplicate Write Memory Error ..................................................................................................186
Error Occurred Reading RIS Copy from SCSI Port X Drive ID................................................186
FYI: Drive (Bay) X is Third-Party Supplied ..............................................................................186
Identify Logical Drive Data did not Match with NVRAM ........................................................187
Insufficient Adapter Resources ..................................................................................................187
Inter-Controller Link Connection Could Not Be Established ....................................................187
Less Than 75% Batteries at Sufficient Voltage..........................................................................187
Less Than 75% of Batteries at Sufficient Voltage Battery Pack X Below Reference Voltage ..188
Logical Drive X Failed Due to Cache Error...............................................................................188
Logical Drive X Status = Failed.................................................................................................188
Logical Drive X Status = Interim Recovery (Volume Functional, but not Fault Tolerant)........189
Logical Drive X Status = Loose Cable Detected........................................................................189
Logical Drive X Status = Overheated.........................................................................................189
To Next Page
Loading...
