EasyManua.ls Logo

HP ProLiant ML350 Generation 4

HP ProLiant ML350 Generation 4
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
174 Reference and Troubleshooting Guide
Attached Drives..........................................................................................................................199
Swapped Cables or Configuration Error Detected. The Maximum Logical Volume Count X...200
System Board is Unable to Identify which Slots the Controllers are in .....................................200
This Controller Can See the Drives but the Other Controller Can't ...........................................201
The Redundant Controllers Installed are not the Same Model...................................................201
This Controller Can't See the Drives but the Other Controller Can ...........................................201
Unable to Communicate with Drive on SCSI Port X, Drive ID Y.............................................201
Unable to Retrieve Identify Controller Data. Controller May be Disabled or Failed.................202
Unknown Disable Code..............................................................................................................202
Unrecoverable Read Error..........................................................................................................202
Warning Bit Detected .................................................................................................................202
WARNING - Drive Write Cache is Enabled on X.....................................................................203
WARNING: Storage Enclosure on SCSI Bus X Indicated it is Operating in Single Ended
Mode...........................................................................................................................................203
Write Memory Error...................................................................................................................203
Wrong Accelerator .....................................................................................................................204
Introduction to ADU Error Messages
This section contains a complete alphabetical list of all ADU ("Array Diagnostic
Utility" on page 101
) error messages.
IMPORTANT: This guide provides information for multiple servers.
Some information may not apply to the server you are troubleshooting.
Refer to the server documentation for information on procedures,
hardware options, software tools, and operating systems supported by
the server.
WARNING: To avoid potential problems, ALWAYS read
the warnings and cautionary information in the server
documentation before removing, replacing, reseating, or modifying
system components.
Accelerator Board not Detected
Description: Array controller did not detect a configured array accelerator board.
Action: Install an array accelerator board on an array controller. If an array
accelerator board is installed, check for proper seating on the array controller
board.

Other manuals for HP ProLiant ML350 Generation 4

Related product manuals