52 Reference and Troubleshooting Guide
2. Install the hard drive.
NOTE: Depending on model purchased, the server may look slightly
different than shown.
3. Determine the status of the hard drive from the hot-plug SCSI hard drive
LEDs (on page 19
).
4. Resume normal server operations.
Installing a Non-Hot-Plug SCSI Hard Drive
1. Power down the server ("Powering Down the Server" on page 21).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 22
).
3. Remove the front bezel door, if necessary ("Removing Front Tower Bezel"
on page 23
).
4. Remove the access panel ("Removing Access Panel" on page 23
).
To Next Page
Loading...
