HP ProLiant ML350 Generation 4p Maintenance And Service Guide

Removal and replacement procedures 27
Redundant system fan
CAUTION: The redundant system fan is not hot-pluggable.
To remove the redundant system fan:
1. Remove the access panel.
2. Remove the redundant system fan cable from the redundant system fan
header on the system board.
3. Remove the fan.
To replace the component, reverse the removal procedure.
Expansion slot cover
To remove the component:
1.
Power down the server ("Powering down the server" on page 16).
2.
Extend the server from the rack, if applicable ("Extending the server from the
rack
" on page 16).
3. Remove the front bezel door, if necessary.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X