To Next Page

To Previous Page

Removal and replacement procedures 33

Processor and heatsink

IMPORTANT: If upgrading processor speed, update the system ROM

before installing the processor.

IMPORTANT: PPM 2 must be installed when processor 2 is installed.

The system fails to boot if the PPM is missing.

To remove a processor and heatsink:

1. Remove the access panel.

2. Disconnect the heatsink connectors from the headers on the system board.

3. Open the heatsink retaining levers.

Other manuals for HP ProLiant ML350 Generation 4p

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant ML350 Generation 4p and is the answer not in the manual?

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X