Maximum Internal
Storage
One of the following
depending on Model
CAPACITY
CONFIGURATION
Hot Plug LFF SAS
144TB
24 x 6TB
Hot Plug LFF SATA
144TB
24 x 6TB
Hot Plug SFF SAS
48TB
48 x 1TB
Hot Plug SFF SATA
57.6TB
48 x 1.2TB
Hot Plug SFF SATA SSD
76.8TB
48 x 1.6TB
Hot Plug SFF SAS SSD
76.8TB
48 x 1.6TB
Hot Plug LFF SATA SSD
38.4TB
24 x 1.6TB
Power Supply
One of the following
depending on Model
HP 500W Flex Slot Platinum Hot Plug Power Supply
HP 800W Flex Slot Platinum Hot Plug Power Supply
HP 1400W Flex Slot Platinum Plus Hot Plug Power Supply
HP Flexible Slot (Flex Slot) Power Supplies share a common electrical and physical design that allows for
hot plug, tool-less installation into HP ProLiant Gen9 Performance Servers. Flex Slot power supplies are
certified for high-efficiency operation and offer multiple power output options, allowing users to "right-
size" a power supply for specific server configurations. This flexibility helps to reduce power waste,
lower overall energy costs, and avoid "trapped" power capacity in the data center.
All pre-configured servers ship with a standard 6-foot IEC C-13/C-14 jumper cord (A0K02A). This jumper
cord is also included with each standard AC power supply option kit. If a different power cord is required,
please check the
ProLiant Power Cables web page
.
To review the power requirements for your selected system, please use the HP Power Advisor Tool
located at
www.hp.com/go/hppoweradvisor
.
Power specifications and technical content for all HP Server power supplies can be found at
www.hp.com/go/proliant/powersupply
.
NOTE:
Mixing of power supplies in the same server is not supported. All power supplies must be of the
same input voltage, output rating, and efficiency rating. If non-matching power supplies are installed,
you may receive an error message and/or experience operational issues with your server.
System Fans
One of the following
depending on Model
Non-redundant
Redundant
1P model
3 fans 6 fans
NOTE:
Fan Redundancy is standard in performance model. Option 725878-B21 includes four fans and
PCIe baffles are required for fan redundant kit.
2P model
4 fans 8 fans
Interfaces
Serial
1
Video
1 (rear)
Network RJ-45 (Ethernet)
4
HP iLO Remote Management Network Port
1 Gb Dedicated
SD Slot
1 (internal)
NOTE:
The Micro-SD slot is not a hot-pluggable device. Customers should not attempt to plug an Micro-
SD card into the Micro-SD slot while the server is powered.
USB 2.0 Ports
5 (2 front, 2 rear, 1 internal)
USB 3.0
3 (2 rear, 1 internal)
QuickSpecs
HP ProLiant ML350 Generation9 (Gen9)
Standard Features
DA - 15035 Worldwide QuickSpecs — Version 2 — 9.23.2014
Page 6
To Next Page
Loading...
Need help?
General
