Hardware options installation 92
5.
Remove the access panel (on page 25).
6. Remove PCI air baffle ("Remove the PCI air baffle" on page 28), if installed.
7. Remove the system air baffle (on page 30).
8. Install an optional Smart Array controller ("Installing an expansion board" on page 76).
9. Remove any installed full-length PCI cards.
10. Remove the fan cage (on page 31).
11. Disconnect the existing SAS cable from the system board connector.
12. Connect the SAS cables:
a. Connect the mini-SAS cable that came with the kit to the empty SAS connector on the drive
backplane.
b. Route the SAS cables through the cable management clips and connect to the Smart Array
controller.
To Next Page
Loading...
