Removal and replacement procedures 30
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1. Shut down the OS as directed by the OS documentation.
2. Press the Power On/Standby button to place the server in standby mode. When the server enters
standby power mode, the system power LED changes to amber.
3. Disconnect the power cords.
The system is now without power.
Remove the server from the rack
To remove the server from an HP, telco, or third-party rack:
1. Power down the server (on page 29).
2. Disconnect the cabling.
3. Extend the server from the rack. Reverse the server installation steps in the documentation that ships with
the rack-mounting option.
4. Press the server rail-release latches, and remove the server from the rack.
5. Place the server on a sturdy, level surface.
Front bezel
Tower servers have a removable front bezel that must be unlocked and opened before accessing the drive
cage, and before removing the access panel.
To remove the component:
To Next Page
Loading...
