8. If an optical drive is installed, disconnect the power cable (1) and data cable (2) from the back of
the optical drive.
Figure 2-30 Disconnecting the Optical Drive Power and Data Cables
9. Disconnect the data cable (1) and power cable (2) from the back of the primary hard drive.
Figure 2-31 Disconnecting the Primary Hard Drive Data and Power Cables
CAUTION: Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A
sharp bend can break the internal wires.
ENWW Installing and Removing Drives 33
To Next Page
Loading...
