2. Insert the primary hard drive “upside down.” Align the hard drive with the primary hard drive bay in
the drive cage so that the bottom of the hard drive is next to the optical drive compartment and the
power and data connectors are up. Slide the drive all the way down into the drive cage until it locks
in place.
Figure 2-34 Installing the Primary Hard Drive
3. Connect the data cable (1) and power cable (2) to the back of the primary hard drive.
NOTE: If the system has only one SATA hard drive, the data cable must be connected to the
dark blue connector labeled SATA 0 on the system board to avoid any hard drive performance
problems.
Figure 2-35 Connecting the Primary Hard Drive Data and Power Cables
ENWW Installing and Removing Drives 35
To Next Page
Loading...
