b. Insert the new battery and position the clip back into place.
Figure D-3 Removing a Coin Cell Battery (Type 3)
NOTE: After the battery has been replaced, use the following steps to complete this procedure.
9. Replace the computer cover.
10. If the computer was on a stand, replace the stand.
11. Plug in the computer and turn on power to the computer.
12. Reset the date and time, your passwords, and any special system setups using Computer Setup.
Refer to the Computer Setup (F10) Utility Guide on the Documentation and Diagnostics CD.
13. Lock any security devices that were disengaged when the computer cover was removed.
ENWW 55
To Next Page
Loading...
