Wi-Fi (802.11b)
Specifications
1,2
Technology
High-speed wireless access to the Internet, email and corporate data
RF Network Standard
IEEE 802 Part 11b (802.11b)
Frequency Band
2.4000 to 2.4835 GHz
2.4465 to 2.4835 GHz (France)
2.4000 to 2.497 GHz (Japan)
Antenna type
Embedded Antenna
Security
WEP 64/128-bit compliant to IEEE 802.11
Compliant to 802.1X (EAP-TLS, PEAP)
WPA
Network Architecture
Models
Ad-hoc (Peer to Peer)
Infrastructure (Access Points Required)
Modulation Technique
Direct Sequence Spread Spectrum
Modulation Schemes
DBPSK, DQPSK, CCK
Receiver Sensitivity –
Packet Error Rate
(8E-2)
11 Mbps: <-80 dBm
5.5 Mbps: <-82 dBm
2 Mbps: <-86 dBm
1 Mbps: <-89 dBm
Maximum Receive Level
-10dBm (1/2/5.5/11 Mbps)
Output Power
15 dBm
Power Consumption
Transmit mode: 1.33 Watts, typical
Receive mode: 1.235 Watts, typical
Media Access Protocol
CSMA/CA (Collision Avoidance) with ACK
Protocols Supported
TCP/IP
IPX/SPX
UDP
Operating Distance
Up to 1000 feet – Open sight
Certifications
All necessary regulatory approvals for countries we support including:
WECA Wi-Fi approval
FCC (47 CFR) Part 15C, Section 15.247&15.249
ETS 300 328, ETS 301 489-6
Low Voltage Directive IEC950
UL, CSA, and CE Mark
NOTES:
1
A standard WLAN (Wi-Fi) infrastructure, separately purchased equipment, and a service contract with a
wireless airtime provider may be required for applicable wireless communication. Wireless Internet use
requires a separately purchased service contract. Check with wireless network service providers for
availability and coverage in your area. Not all web content available.
2
Wireless access points required and are not included. Availability of public wireless access points limited.
Wireless Internet use may require separately purchased Internet service contract.
QuickSpecs
HP iPAQ rx1950 Pocket PC
Standard Features
DA - 12255 North America — Version 5 — March 23, 2006
Page 6
To Next Page
Loading...
