HP Scanjet 7000 User Manual

• Scanning the following types of documents might result in paper jams or damage to
the documents.
Wrinkled or creased
documents
Curled documents
Torn documents Documents with paper clips
or staples
Carbon paper Coated paper
Extremely thin, translucent
paper
Paper with adhesive notes or
flags attached
Photos Overhead transparencies
Papers that are stuck
together
Paper with wet substances
such as glue or correction
fluid
• Smooth out any folds or curls in your documents before placing them into the feeder.
If the leading edge of a document is curled or folded, it may cause a paper jam.
• When loading paper that is smaller than 74 mm (2.9 in) in one dimension (such as
business cards), place the pages with the long side parallel to the paper guides.
• To scan fragile documents (such as photos or documents on wrinkled or very
lightweight paper), place the document in a clear, heavyweight document sleeve no
wider than 216 mm (8.5 in) before loading them into the document feeder.
TIP: If you do not have an appropriately-sized document sleeve, consider using
a sleeve intended for use in a ring binder. Trim the ring-side edge so the sleeve
is no more than 216 mm (8.5 in) wide.
• Make sure that the hatch on the document feeder is securely latched. To properly
close the hatch, press until you hear a click.
• Adjust the paper guides to the width of the documents. Make sure that the paper
guides touch the edges of the original. If there is any clearance between the paper
guides and the edges of the documents, the scanned image might be skewed.
• When placing a stack of documents into the feeder, gently set the stack in the
document feeder. Do not drop the stack into the feeder and do not tap the top edge
of the stack after you have placed the stack in the document feeder.
• Clean the scanning rollers if the rollers are visibly dirty or after scanning a document
that has pencil writing on it.
See also
Clean the paper path
Clean the rollers
Scanner paper path problems
Chapter 2
8 Use the scanner

HP Scanjet 7000 Specifications

General

Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Storage relative humidity (H-H)	0 - 90 %
Operating relative humidity (H-H)	15 - 80 %
Package weight	10200 g
Sustainability certificates	ENERGY STAR
Input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	40 W
Display	LCD
Scanner type	Sheet-fed scanner
Product color	Black, Silver
Film scanning	-
Color scanning	Yes
Grayscale levels	256
Input color depth	48 bit
Maximum scan size	216 x 864 mm
Output color depth	24 bit
ADF scan speed (b/w, A4)	40 ppm
ADF scan speed (color, A4)	35 ppm
Optical scanning resolution	600 x 600 DPI
Duplex ADF scan speed (b/w, A4)	80 ipm
Duplex ADF scan speed (color, A4)	70 ipm
Safety	IEC 60950-1, CCC, GOST, BSMI, NOM
Minimum scan size	50.8 x 73.6mm
Image formats supported	BMP, JPG, PNG, TIF
ISO A-series sizes (A0...A9)	A4, A5, A6, A8
Scanning media types supported	Card stock, Envelopes, Plain paper
Maximum ISO A-series paper size	A4
Auto Document Feeder (ADF) media weight	49 - 120 g/m²
Scan to	E-mail
Sensor type	CCD
Scan drivers	ISIS, TWAIN, WIA
Scan file formats	BMP, DOC, HTM, JPG, OPF, PDF, PNG, RTF, TIFF, TXT, UNICODE, WPD, XLS, XPS
Daily duty cycle (max)	2000 pages
Auto document feeder (ADF) input capacity	50 sheets
USB version	2.0
Standard interfaces	USB 2.0
Minimum RAM	512 MB
Mac compatibility	No
Minimum processor	1.3 GHz
Minimum storage drive space	300 MB
Minimum system requirements	USB 1.1 CD-ROM 1024x768 SVGA
Compatible operating systems	Windows 7 Windows Vista Windows XP Professional (32/64-Bit) Windows XP Media Center Windows XP Home Windows 2000
Windows operating systems supported	Windows 2000, Windows XP Home, Windows XP Professional, Windows XP Professional x64
Electromagnetic compatibility	FCC, CISPR, ANSI, CAN/CSA–CISPR, EN, AS/NZS CISPR, CNS

Weight and Dimensions

Depth	280 mm
Width	320 mm
Height	246 mm
Weight	7280 g