HP Scanjet Enterprise 7000 s2 - Replace the rollers

Replace the rollers
Replace the rollers under the following conditions:
●
When the Maintenance Recommended dialog box indicates they are due for maintenance.
●
If you experience repeated document jams and cleaning the rollers did not help.
The roller replacement kit contains rollers and installation instructions. To order the replacement kit,
go to
www.hp.com/support.
NOTE: The roller replacement kit is a consumable and is not covered under warranty or standard
service agreements.
To replace the rollers, follow these steps:
1. Press the Power (
) button to turn off the scanner, and then disconnect the USB cable and
power supply from the scanner.
2. Replace the rollers as described in the instructions that were included with the replacement kit.
3. Close the document feeder hatch, and then reconnect the USB cable and power supply to the
scanner.
4. Press the Power (
) button to turn on the scanner, and then update the scanner maintenance
history:
a. Press the Tools (
) button on the scanner front panel to open on the HP Scanner Tools
Utility.
b. Under Record Replacement, click Record Replacement to log this replacement activity
and update the roller replacement history.
For more information, see the HP Scanner Tools Utility Help.
NOTE: HP recommends that you replace the rollers every 100,000 scans.
The HP Scanner Tools Utility can remind you when service is needed, which depends on many
conditions and might be sooner than this replacement interval.
Replace the rollers 39