Replace the separation pad
The roller replacement kit includes a replacement separation pad. Always replace the separation pad
when you replace the rollers. To order the roller replacement kit, see
www.hp.com/buy/parts.
TIP: The scanner software CD which came with your product includes an animation which guides
you through removing and replacing the separation pad. This animation is also available at
www.hp.com/support.
To replace the separation pad, follow these steps:
1. Press the Power (
) button to turn off the scanner, and then disconnect the USB cable and
power supply from the scanner.
2. Open the automatic document feeder (ADF) hatch.
3. Press forward (toward the rear of the ADF) on the separation pad latch to release the separation
pad.
TIP: This is easier to do if you raise the ADF input tray slightly.
30 Chapter 4 Care and maintenance
To Next Page
Loading...