Replace the front panel
TIP: The scanner software CD which came with your product includes an animation which guides
you through removing and replacing the front panel. This animation is also available at
www.hp.com/
support.
To replace the front panel, follow these steps:
1. Press the Power (
) button to turn off the scanner, and then disconnect the USB cable and
power supply from the scanner.
2. Raise the scanner lid.
3. Loosen the front panel cover.
a. Locate the access hole on the underside of the front panel, and press the bottom end of a
pen upward into the hole.
b. While pressing the pen upward, use your fingers to gently pry at the tab location shown,
lifting the front panel gently as you release the tab.
4. Continue to pry at the remaining tab locations, lifting the front panel gently as you release each
tab.
Replace the front panel 33
To Next Page
Loading...