17
1 Secure the tape drive into place with screws.
If you used mounting hardware that screws to the front of the computer, use the screws you removed
in step 2 to fix the drive in place.
If your computer does not require mounting hardware, check that the holes in the chassis are aligned
with the holes in the sides of the drive and use the four screws provided with the rail kit to secure the
drive, as shown in figure 6.
2 Replace the cover on the computer.
Dlt1getstart_int.fm Page 17 Thursday, November 16, 2000 1:47 PM
To Next Page
Loading...
