HP Tc4400 - Compaq Tablet PC - Page 18

2–12 Security
Passwords
Entering a DriveLock password
Be sure that the hard drive is inserted into the computer (not into
an optional docking device or external MultiBay).
At the DriveLock HDD Bay Password prompt, type your user
or master password (using the same kind of keys you used to set
the password), and then press
enter.
✎
After 2 incorrect attempts to enter the password, you must
restart the computer and try again.
Changing a DriveLock password
To access the DriveLock settings in Computer Setup:
1. Open Computer Setup by turning on or restarting the
computer, and then pressing
f10 while the “F10 = ROM
Based Setup” message is displayed in the lower-left corner
of the screen.
2. Use the arrow keys to select Security > DriveLock
passwords, and then press
enter.
3. Use the arrow keys to select the location of the internal hard
drive, and then press
f10.
4. Use the arrow keys to select the field for the password you
want to change. Type your current password in the Old
password field, and then type the new password in the
New password field and in the Verify new password field.
Then press
f10.
5. To save your preferences, use the arrow keys to select File >
Save Changes and Exit, and then follow the instructions on
the screen.
Your preferences go into effect when the computer restarts.