HP Tc4400 - Compaq Tablet PC - Page 19

Passwords
Security 2–13
Removing DriveLock protection
To access the DriveLock settings in Computer Setup:
1. Open Computer Setup by turning on or restarting the
computer, and then pressing
f10 while the “F10 = ROM
Based Setup” message is displayed in the lower-left corner
of the screen.
2. Use the arrow keys to select Security > DriveLock
passwords, and then press
enter.
3. Use the arrow keys to select the location of the hard drive,
and then press
f10.
4. Use the arrow keys to select Disable in the Protection field,
and then press
f10.
5. Type your master password in the Old password field. Then
press
f10.
6. To save your preferences, use the arrow keys to select File >
Save changes and exit. Then follow the instructions on the
screen.
Your preferences go into effect when the computer restarts.