HP V241 User Manual

9
characters (only applicable to VGA
input)
Horizontal position
To adjust the horizontal position of
an image (only applicable to VGA
input).
Vertical position
To adjust the vertical position of an
image (only applicable to VGA
input).
Custom Scaling
Selects the method on how
displayed information on the
monitor will be formatted.Select
Fill to Screen – image fills the entire
screen and may look distorted or
elongated because of
non-proportional scaling of height
and width.
Fill to Aspect Ration – image is
sized to fit the screen and maintains
proportional image.
Sharppness
Adjusts the screen imageto look
sharper or soft. (range:1~6)
Dynamic Contrast
Turns Dynamic Contrast Ratio On
or Off.The factory default is Off.
OSD Control
Provides a menu for adjusting the
on-screen display(OSD)control.
OSD position
To adjust OSD position for your
monitor.
Horizontal OSD
Position
To adjust the visual position of the
OSD menu to the right or left of the
screen. The factory default
horizontal position value is 97.
Vertical OSD
Position
To adjust the visual position of the
OSD menu up or down the screen.
The factory default vertical position
value is 13.
OSD Transparency
To adjust the transparency to
enable transparent background
information under the OSD.
(range:0~7)
OSD Timeout
To set the OSD display time (in
seconds) after the last pressing the

HP V241 Specifications

General

Screen Size	23.8 inches
Resolution	1920 x 1080 (Full HD)
Panel Type	IPS
Aspect Ratio	16:9
Refresh Rate	60Hz
Brightness	250 cd/m²
Contrast Ratio	1000:1
Viewing Angle	178° horizontal / 178° vertical
Color Gamut	72% NTSC
VESA Mount	100 x 100 mm
Response Time	5 ms (gray to gray)
Inputs	1 x VGA, 1 x HDMI