Problems
CMOS Test Error 2of2
Advanced Troubleshooting
Have you checked that... How
Power is correctly connected to the
system board
!
1 Disconnect the power cord.
2 Remove the PC’s cover.
3 Check the power connector is correctly attached to the system
board (refer to page 73).
4 Close the PC, reconnect the power cord and check that the PC
boots (starts).
You don’t need to restore the default
configuration settings
!
1 Switch the PC OFF then ON.
2 When the message Press F2 to Enter Setup appears, press the F2
key.
3PressF9 to restore default values.
4PressF10 to exit the Setup program saving changes.
If the problem persists, contact your authorized support provider
To Next Page
Loading...
