HP vf51 User Manual

Note: Auto Configuration uses state-of-the-art signal processing algorithms based on the image
displayed on your screen. Therefore, you should not change the image on your screen
while Auto Configuration is running.
Once you have executed Auto Configuration for a particular mode, the monitor will store the new
values in its permanent memory.
To execute Auto Configuration using the Direct Key function:
1. Make sure the OSD Main Menu is not displayed onscreen. Press the Down (▼) button to open
the AUTO CONFIG submenu and start running Auto Configuration.
2. After Auto Configuration has finished, you should have a stable and clear image.
Adjusting Brightness Using the Direct Key
To adjust brightness directly:
1. Make sure the OSD Main Menu is not displayed onscreen. Press the Up (▲) button to open the
BRIGHTNESS submenu.
2. Press the Up (
▲) or Down (▼) buttons to increase or decrease the brightness setting.
3. Press the Select button to close and exit the BRIGHTNESS menu.
21
MAIN PAGE

HP vf51 Specifications

General

Brand	HP
Model	vf51
Category	Monitor
Language	English